Interpreting the Sharpe Ratio
by Wayne A. Thorp, CFA
The relationship between risk and return is an essential concept in finance, which argues that riskier investments should compensate investors with higher returns and safer investments should not experience exorbitant price fluctuations.
When comparing the performance of two securities, funds or portfolios, investors must consider risk-adjusted returns to see if they are being adequately compensated for the risk they are assuming. The goal is to achieve the largest return per unit of risk.
In this article
Share this article
William Sharpe devised the Sharpe ratio in 1966 to measure this risk/return relationship, and it has been one of the most-used investment ratios ever since. Here, we discuss how to calculate and interpret the Sharpe ratio.
Components of the Ratio
Much of the ratio’s fame is attributable to its simplicity, as it comprises only three components. The original formula Sharpe presented in 1966 is as follows:
Sharpe Ratio = (R_{x} – R_{f}) ÷ StdDev(R_{x})
Where:
R_{x} = average rate of return from investment X
R_{f} = risk-free rate
StdDev(R_{x}) = standard deviation of R_{x}
When analyzing the Sharpe ratio, the higher the value, the more excess return investors can expect to receive for the extra volatility they are exposed to by holding a riskier asset. Similarly, a risk-free asset or a portfolio with no excess return would have a Sharpe ratio of zero.
Average Return
The Sharpe ratio was originally developed as a forecasting tool, but it can also be used to calculate a historical risk-adjusted return. Expected average returns are used to calculate the forward-looking ratio, whereas actual returns are used in the historical ratio.
The expected return is also known as the required rate of return because it represents the minimum return investors require to compensate them for the added risk, which includes both the riskiness of the investment and the time value of money.
Risk-Free Rate
The risk-free rate is the return investors require to compensate for the time value of money alone. Typically, investors use the return on U.S. Treasury bills for the risk-free rate because it is reasonable to assume the U.S. government will not default on its debt obligations, and thus investors need only be compensated for the time their capital is tied up in the security.
The Sharpe ratio requires that R_{f }represents the average return of the risk-free rate over the time period under evaluation. When analyzing a three-year period, investors must average the rate of return on T-bills over the same three-year period.
Traditionally, the shortest-dated bill is used since it is the least volatile. However, some argue the risk-free security should match the duration of the investment. Since equities theoretically have an infinite duration, one could argue that the longest-dated bill should be used.
Standard Deviation
The standard deviation of a security measures how far returns deviate on average from its mean (or average) return. Standard deviation is a common indicator used to measure the volatility, and thus the riskiness, of an investment. For instance, an investment that deviates only 3% from its mean on average is judged as less risky than an investment with a 20% average deviation.
Using the Sharpe Ratio
As an example of how to calculate and interpret the Sharpe ratio, we downloaded monthly data on the S&P 500 index, the S&P MidCap 400 index, the S&P SmallCap 600 index and 90-day T-bills from January of 2008 to July of 2012 into an Excel spreadsheet.
Since the S&P 500 consists of 500 large-cap U.S. companies, it should theoretically be the least volatile and also the least rewarding. Similarly, the S&P SmallCap 600 should be the most volatile and also the most rewarding of these three indexes, as small-cap stocks are generally considered to be riskier.
When computing the Sharpe ratio, investors must first make sure they have an abundance of consistent and comparable data points. The more data points we use, the more likely distribution is normal and thus the more accurate our results will be. Although we use monthly data here, shorter intervals can be used but are more volatile and thus may require a longer time period to compensate for the added volatility.
In Excel, we used the function “=Average” to calculate the average monthly return and the function “=StDevP” to calculate standard deviation based on the entire population. [The function “=StDevP” is used when the entire population is present or when an individual is only interested in the sample and does not want to generalize the data to represent the entire population. For sampling, the function “=StDev” can be used. Basing the standard deviation on the entire population may be preferable when comparing historical performance, whereas sampling may be preferable when forecasting.] We then apply the components to the aforementioned formula to get the Sharpe ratio.
The resulting Sharpe ratios shown in Table 1 indicate that the S&P SmallCap 600, with a Sharpe ratio of 0.06, provided the highest monthly return per unit of risk out of the three indexes over the 4½-year period. As expected, the S&P 500, with a Sharpe ratio of 0.003, had the lowest volatility (standard deviation of 5.67%) and produced the lowest average return (0.05%). Meanwhile, the S&P SmallCap 600 experienced the most volatility, with a standard deviation of 7.12%, and the largest returns, averaging 0.46%.
Therefore, the S&P SmallCap 600 earned an average excess return of 6% per unit of risk, whereas the S&P 500 earned an average excess return of 0.3% per unit of risk. Although the S&P SmallCap 600 is more volatile and thus riskier, holders of the index were much better compensated for the risk compared to holders of the S&P 500 during that period. If investors expect this to continue in the future, they should favor the S&P SmallCap 600 over the S&P 500, as it would offer a higher expected return per unit of risk than the S&P 500.
Note that since all three indexes constitute diversified portfolios and that since diversification reduces volatility, their standard deviations are quite similar. Furthermore, historical performance is not a guarantee of future results. In general, small caps will outperform large caps when the market is improving, but small caps will severely underperform when the market is deteriorating. Although choosing the investment with the highest Sharpe ratio is logical, diversification and risk aversion should be considered first.
The Ratio’s Weaknesses
Relative Value
The Sharpe ratio provides valuable information only when compared with another investment. To illustrate, if Company A has a Sharpe ratio of 1.0, does that make it a good investment? What if its competitor, Company B, has a Sharpe ratio of 3.0? All else equal, Company B is more attractive because, although Company A appears to have a high ratio, Company B’s ratio is better.
S&P | S&P | |||
S&P | MidCap | SmallCap | ||
500 | 400 | 600 | T-Bills | |
Average Monthly Return (%) | 0.05 | 0.40 | 0.46 | 0.03 |
Monthly St. Deviation (%) | 5.67 | 6.78 | 7.12 | |
Sharpe Ratio | 0.0031 | 0.0544 | 0.0601 | |
Monthly Returns (%) | ||||
1/31/2008 | -6.12 | -6.24 | -4.97 | 0.27 |
2/29/2008 | -3.48 | -2.00 | -3.15 | 0.18 |
3/31/2008 | -0.60 | -1.14 | 0.25 | 0.11 |
4/30/2008 | 4.75 | 7.61 | 3.92 | 0.11 |
~ | ~ | ~ | ~ | ~ |
4/30/2012 | -0.75 | -0.52 | -1.32 | 0.01 |
5/31/2012 | -6.27 | -6.42 | -6.38 | 0.01 |
6/30/2012 | 3.96 | 1.73 | 4.04 | 0.01 |
7/31/2012 | 1.26 | -0.12 | -0.84 | 0.01 |
Source: standardandpoors.com |
Moreover, negative Sharpe ratios, which are quite common during bear markets, do not provide useful information because the risk-free asset is then outperforming the investment on a risk-adjusted basis. In that case, investors often flood the bond market in search of the highest risk-adjusted returns available.
Total Risk
Since standard deviation measures total risk, the Sharpe ratio does not determine what investment is best for a diversified portfolio, rather it shows which investment is better of the two being compared. The total risk of an investment comprises both firm-specific and systemic risk, whereas a well-diversified portfolio should contain virtually no firm-specific risk because it is offset by the other securities. Therefore, it may be appropriate to choose an investment with a lower Sharpe ratio in the interest of maintaining a well-diversified portfolio.
Normal Distribution
Standard deviation requires that an investment’s returns are normally distributed. That is, they must take the shape of a bell curve. The Sharpe ratio is not a suitable measurement for investments with asymmetric expected returns.
Even if returns are normally distributed, bell curves have real limitations. For instance, they do not take big market moves into account, which can impact long-term returns and affect leveraged investments.
Furthermore, the time period used in the calculation will affect results. Going too far back may not provide an accurate representation of the current situation.
Volatility
Standard deviation includes movement in every direction, which many consider a weakness because it does not differentiate between upside and downside volatility.
However, because standard deviation and volatility measure the predictability of an investment, which is then translated into risk, high volatility means returns are inconsistent. Strong upside performance of a highly volatile stock can turn severely negative in an instant; thus it is still a risky investment.
Wayne A. Thorp, CFA, is senior financial analyst at AAII and editor of Computerized Investing. Follow him on Twitter @AAII_CI.
Discussion
Doug from New York posted 10 months ago:
Given that a Sharpe Ratio can be driven toward INFINITY by reducing the StdDev(Rx) toward zero, one really has to watch for earnings smoothing when using the Sharpe Ratio!
As an outrageous sort of example, suppose that a company had annual returns of 4%,5%,9%,4%. By simply deciding to give management a "special bonus" (call it the Sharpe Ratio Maximization bonus :-)) equivalent to the difference of these annual returns from some attainable return like 3% (and why shouldn't management receive more when returns are higher?), we can reduce the net return to 3%,3%,3%, and 3%.
Add back in a *little* variability (to avoid StdDev(Rx)=0), say by having higher expenses in some years, and we can make the Sharpe Ratio as high as we like, at the mere cost of a somewhat lower average return.
Mac from Massachusetts posted 10 months ago:
Could you offer more specifics on how to re-create the T-bill risk-free rate shown in Table-1? My attempt with info I downloaded from www.treasury.gov/resource-center/data-chart-center/... led me to calcs that were way off. Thanks.
Mac from Massachusetts posted 10 months ago:
Could you offer more specifics on how to re-create the T-bill risk-free rate shown in Table-1? My attempt with info I downloaded from www.treasury.gov/resource-center/data-chart-center/... led me to calcs that were way off. Thanks.
Gareth Degolier from Minnesota posted 4 months ago:
First of all, thanks for an informative article on the Sharpe Ratio.
Secondly, you say that "translated into risk, high volatility means returns are inconsistent. Strong upside performance of a highly volatile stock can turn severely negative in an instant; thus it is still a risky investment."
I know that it is conventional wisdom, but I don't buy that volatility equates to risk. There are other kinds of risk that should be emphasized more than volatility for either traders or investors. With a highly volatile stock, the reverse of the above statement is also true. Strong downside performance of a highly volatile stock can turn significantly positive in an instant; thus creating a lower entry point and potentially higher returns assuming, strong fundamentals.
Justin Morrill from Colorado posted 4 months ago:
Thanks for the Sharpe ratio explanation.
While it's admittedly simple to calculate the Sharpe ratio in comparing several equities, I have come to use Beta as a proxy for standard deviation when screening a universe of stocks for possible investment. I believe that beta is a reasonable proxy since it is a measure of the volatility of an individual stock versus the volatility of the entire market. I find that this method is easier since beta of individual equities is widely published, and requires no calculation. I calculate the risk-adjusted-return by dividing the expected percentage return (equity price growth plus dividend over the same period) divided by beta. With the Treasury Bill rate near zero for the last several years, I currently gnore the risk-free expected return in this analysis. Just as with the Sharpe ratio, the higher the calculated value of this alternate ratio, the better the potential risk-adjusted-return.
Any comments on this approach?
Tony from Maryland posted 4 months ago:
Something to think about:
"If investors rely solely on quantitative risk measures such as the the ones discussed here, real risks can escape detection until the damage has been done." - Arijit Dutta, Associate Director of Mutual Fund Analysis with Morningstar
"Thus, standard deviation, the most frequently used risk measure, is likely to understate the true downside of a portfolio." - Arijit Dutta, Associate Director of Mutual Fund Analysis with Morningstar
"With 20% declines occurring, on average, every decade or so, you'd think that the standard risk models that investors use to make their asset-allocation decisions would assign a significant probability that these events will occur. Think again." - Paul Kaplan, Ph.D., CFA and V.P. of Morningstar's Quantitative Research
"I think the simple message is that there's much more risk than there appears to be and that the standard deviation doesn't capture all the risk." - Roger Ibbotson, Founder of Ibbotson Assoc.
IMO, there are tree factors to consider when evaluating risk;
1. Predicting the probability of decline with a certain time frame
2. Predicting the length of the decline
3. Predicting the severity of the decline
Is their anyone who has been able to predict the answers to these questions to an acceptable degree of certainty?
At the end of the day, risk management calculations can only tell us about the past, and nothing of the future.
Doug from New York posted 3 months ago:
Justin Morrill wrote:
[
I calculate the risk-adjusted-return by dividing the expected percentage return (equity price growth plus dividend over the same period) divided by beta.
]
So, this is basically the "Treynor Ratio".
Using a similar technique to the one I mentioned above, for the Sharpe Ratio, a company can drive beta toward zero (just keep the net earnings REALLY STABLE and the beta ought to decrease). If they can keep their expected percentage return ABOVE zero, they can drive your ratio toward infinity.
(Basically, I think ratios like this allow the denominator to be way too important, especially if it can be manipulated toward zero.)
Chris Smith from Iowa posted 2 months ago:
I agree with Gareth that volatility does not necessarily equate with risk, especially if no one is holding a gun to your head forcing you to close out your position at the most inopportune time.